Anti Lag Valve - 40mm
Port Anti-Lag valve for Industrial valves
Anti Lag Valve - 40mm
Port Anti-Lag valve for Industrial valves
The 40mm Port Anti-Lag valve for Industrial valves , introduced in 2021, is based on the successful 30-34mm ALS valve originally designed in 2011 and has been on race winning cars in Rally Championships and RallyX.
Air from the plenum or compressor (depending on the plumbing used on your engine) is fed into the primaries through a 40.00mm (1.574”) single outlet port.
An alternative to the single port outlet is a 4 port outlet, where air is fed into the primaries through 4 tubes with a bore of 15.80mm (0.622”).
Cold air is fed into the ALS through a Wiggins fitting (Dash 28) with a bore of 42.90 (1.688”).
Designed to cope with the extreme conditions experienced during racing, the 40mm port ALS Valve was designed with high performance and exceptional quality parts, so as not to compromise reliability:
- Stainless steel casting
- Stainless Steel, 13-8 PH valve
- Austenitic Stainless Steel spring - this is available in many different spring rates, depending on your boost requirement.
- Aluminium billet machined valve guide housing
- Colsibro valve guide
- Viton Quad Ring seal to valve stem
- Top-hat style Nomex-reinforced fluoropolymer rolling membrane
- Industria Valves not included – to be supplied by customer
- Single port stainless steel outlet ring OR 4 port outlet ring supplied.
- Clamp supplied for the outlet rings
